Performance
Performance
Software
Software
calibrations for:
calibrations for:
  • audi ®

GIAC performance software for the audi A3 8P 2005 - 2012

2.0 Turbo TSI


Engine
Controllers


Info
GIAC Stage 1 Plus adds horsepower, torque and more throttle response throughout the power band. A is required to run this calibration.
Quality intake and exhaust upgrades will improve performance.
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
244 HP  275 Ft-Lbs
GIAC Race Mode**
260 HP  290 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 98 RON equivalent fuel for optimum results.
** 106 RON equivalent fuel for optimum results.
Dyno Plots
thumb
Supported ECUs
8P0907115J
8P0907115M
8P0907115Q
8P0907115AG
8P0907115AH
8P0907115AE
8P0907115AM
8P0907115AN
8P0907115AT
8P0907115AS
8P0907115BA
8P0907115BB
8P0907115BC
Info
GIAC Stage 2 adds horsepower, torque and more throttle response throughout the power band. A intake (with a good MAF signal) and exhaust is required to run this calibration.
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
270 HP  300 Ft-Lbs
GIAC Race Mode**
295 HP  310 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 98 RON equivalent fuel for optimum results.
** 106 RON equivalent fuel for optimum results.
Dyno Plots
thumb
Supported ECUs
8P0907115J
8P0907115AE
Info
GIAC Stage 3 K04 adds horsepower, torque and more throttle response throughout the power band. A K04, stock injectors, FMIC, TBE, Intake is required to run this calibration.
OEM Horsepower
and Torque
197 HP  207 Ft-Lbs
GIAC Pump Mode*
315 HP  340 Ft-Lbs
GIAC Race Mode**
350 HP  350 Ft-Lbs

HP and Torque figures are average engine estimates derived from wheel power and acceleration testing.
* 98 RON equivalent fuel for optimum results.
** 106 RON equivalent fuel for optimum results.
Dyno Plots
thumb
Supported ECUs
8P0907115AE


Transmission Controllers


Info
GIAC's two stages of DSG software truly optimize launch control, shift and torque limiter features for the end users performance modifications. Matching this program with the GIAC engine calibration will give the best results.
* Faster, smoother transitions between gears
* Launch control limiter set at 3700 RPM
* Hard rev limiters slightly bumped over stock to be compatible with most aftermarket tunes
* Remapped sport mode "drive program" with improved ability to hold gears and overheating protection
* No automatic kick down in manual mode
* Increased torque limits set to over 500 nM
Supported ECUs
02e300051R_1975
02e300053n_2207


Other products



thumb
Hand Held Flashloader

GIAC's Flashloader Handheld Switcher allows users to switch between GIAC-tuned software programs with the touch of a button. The product is a pocket-sized,hand-held device that plugs directly into the DME port. It uses serial flashing technology and requires no additional hardware within the DME.

Switching is performed by selecting the desired mode with the touch buttons. Cycling the ignition will save the new mode to the ECU's memory and retain its state until switched again.
thumb
Fuel Pump - 20T

Fuel pump for the MK7, MK6 and MK5 2.0 turbo platforms